Our practice grade dog walks are fabricated from 1" welded steel tubing with one, 1/2" steel tubing truss welded underneath to minimize flex in the ramps and center section, and 1/2" exterior grade plywood skins.  The fabricated steel frames are sandblasted and powder coated, and the wood skins are painted with a premium exterior flat paint and textured with your choice of either sand or rubber.  You can order your dog walk in virtually any color combination you desire, however it is far cheaper to order it unfinished and paint it yourself. 

Our standard practice grade dog walks have 8' ramps and center section instead of 12' like our competition dog walk, and are 33" high instead of 48" in order to maintain the required ramp angles that you will find on the full size dog walks. 

Practice dog walks shown completely finished on the left and unfinished on the right

Our practice dog walks are fabricated with legs that are welded to the frame and set at one height so they are not able to be lowered, however we do give an option for adjustable legs that can be lowered.   We can build your dog walk ramps with or without slats.

Our adjustable dog walk legs are designed so that they can be used at their full height or easily lowered for training young dogs.  A lowered dog walk is far less intimidating to a young dog and they will gain confidence going across the dog walk much quicker when it is introduced to them at the lower height.  When lowered, our practice dog walks are approximately 18" high.

The dog walk is easily lowered by pulling one pin and rotating the legs down.  To raise them again, simply rotate the legs back up and re-insert the pin.  This is easily done by one person.  You can also order your dog walk with or without wheels, on one or both sides.  Our standard wheel is a 6" diameter steel wheel with rubber tire and sealed ball bearing rollers.  We weld an axle to the dog walk leg and the wheel is then attached to the axle. 

We offer our practice dog walks either unfinished or completely finished and ready to use.  If you are handy with a can of spray paint and a paint roller, you can save significant $$ by purchasing your dog walk unfinished and painting it yourself.  The average person (even you ladies) can easily paint a dog walk in one weekend, and instructions for painting the frame and plywood and applying the non-skid finish are included with each unfinished dog walk.

Our practice grade dog walk prices are as follows:

 

COMPONENT	PRICE
Unfinished dog walk, bare steel frame and unpainted wood skins, no slats or wheels (Add $160 for powder coated frame with unfinished wood)	$300
Finished dog walk, powder coated frame and painted wood skins, sand texture, no slats or wheels	$595
Adjustable leg option	add $75
Add wheels	$25 each or 4 for $80
Add AKC or USDAA regulation slats	$60
For rubber surfacing add $40 to the finished price above for non slatted equipment and add $80 for slatted equipment

To see our paint and powder coating colors please go to our Colors page.

To see our granulated rubber colors please go to our Rubber Surfacing Page

For delivery rates please see our Delivery page.